Skip to main content
Back to Chemistry

REACTIONS · STOICHIOMETRY

Hydrate & Gravimetric Analysis Lab

AP Chemistry
File ▾

AP CHEMISTRY · UNITS 1 AND 4

Chemistry by the gram: weigh it, heat it, precipitate it.

A balance that reads to 0.001 g can tell you a formula. Drive the water out of a hydrate and the mass lost gives the mole ratio; turn the chloride in a salt into solid silver chloride and its mass gives the percent chloride.

  1. Weigh the empty crucible (or filter crucible) on the analytical balance.
  2. Heat the hydrate, or precipitate the chloride with silver nitrate and filter it.
  3. Dry and weigh again and again until two readings agree within 0.002 g, then record the trial.

Choose where to start:

About this model

Water of hydration. A hydrate MXₙ·xH₂O loses its water on heating and leaves the anhydrous salt. The model keeps a share of the remaining water after each heating (0.12 of it; an illustrative drying rate) until two readings agree within 0.002 g. Then x = (g water ÷ 18.015) ÷ (g anhydrous ÷ M). The hydrates are the stable classroom ones: CuSO₄·5H₂O (blue; anhydrous CuSO₄ is white), BaCl₂·2H₂O and MgSO₄·7H₂O (Epsom salt) (OpenStax Chemistry 2e, sections 3.1 and 4.5).

Chloride by gravimetry. Ag⁺(aq) + Cl⁻(aq) → AgCl(s). Silver nitrate (0.200 mol/L) is added until a test drop gives no new cloud, so Ag⁺ is in excess and every chloride ion is in the precipitate. The AgCl is collected in a sintered-glass filter crucible, washed, dried at 110 °C and weighed to constant mass (the wet cake starts with 0.080 g of water, 0.12 of which stays after each drying: illustrative). % Cl = g AgCl × 35.45 ÷ 143.32 ÷ g sample × 100.

Molar masses (g/mol). H₂O 18.015, CuSO₄ 159.61, BaCl₂ 208.23, MgSO₄ 120.37, AgCl 143.32, Cl 35.45, NaCl 58.44, KCl 74.55, CaCl₂ 110.98, MgCl₂ 95.21, from standard atomic weights.

Mistakes and their sizes (illustrative). Spattering loses 3 % of the crucible contents; a red-hot crucible decomposes 2 % of the CuSO₄ to CuO + SO₃ per heating (CuSO₄ starts to break down above about 600 °C); cooling in open air puts back 0.015 g of water; a warm crucible reads 0.010 g light (rising warm air pushes up on the pan); an unwashed precipitate keeps 0.010 g of dried silver nitrate; a torn filter loses 4 % of the AgCl. The directions are real; the sizes were chosen to be easy to see.

What is left out. The balance reads to 0.001 g with a reading error inside ±0.0004 g, and nothing else varies (no drafts, static or temperature drift). AgCl slowly darkens in light, losing a little chlorine; the model ignores that. Real hydrates can lose their water in stages at different temperatures; the model removes it smoothly. The bench is a schematic and not to scale.

What am I looking at?

How the lab works. Pick Explore or one lab at the top. Each lab has five tabs: Pre-lab, Bench, Data & graph, Claim · Evidence · Reasoning, and Test. On the Bench, the coach names your next step and the button for it is highlighted; steps tick themselves as you work. Press What do I do now? when you’re stuck.

Water of hydration bench. On the left, an analytical balance (reads to 0.001 g) inside a glass draft shield. In the middle, a porcelain crucible with its lid ajar sits in a clay triangle on an iron ring above a Bunsen burner. On the right, a glass desiccator with blue drying beads under a porcelain plate, and the jar of hydrate. Crucible tongs carry the crucible from place to place. Blue copper(II) sulfate turns white as its water leaves as steam.

Percent chloride bench. The balance; a buret of 0.200 M silver nitrate over a beaker of the dissolved salt, where white silver chloride forms and settles; a filter flask with a sintered-glass filter crucible under suction; a drying oven at 110 °C; and the desiccator.

The graph and readings. Beside the bench, every balance reading for the trial on the bench is listed, with the change from the reading before. The graph shows mass against heating (or drying) number: it levels off at constant mass.