Skip to main content
Back to Biology

HOMEOSTASIS · MUSCLES

Muscle Contraction Lab

Intro college
File ▾

INTRO COLLEGE · ANATOMY & PHYSIOLOGY

How does a muscle make force?

An isolated muscle sits between a stimulator and a force sensor. Stimulate it, watch the force trace, and zoom in to the sarcomere and a single myosin head to see what makes the force.

  1. Set the stimulator (or the length), then press ▶ Stimulate to run one second.
  2. Read the force trace, the sarcomere and the cross-bridge close-up.
  3. Record the run, change one setting, and run again.

Goes further than AP Biology (Unit 2 cell structure, Unit 3 energy use, Unit 4 cell signaling): the sliding filament model, cross-bridge cycling, summation and tetanus, and the length–tension curve, as in a first-year anatomy and physiology course. Algebra only.

Choose where to start:

About this model

A teaching model, not a recording. Force is in units of one twitch at the best length (1 = the peak of one twitch). The shapes follow OpenStax Anatomy & Physiology 2e §10.3–10.4; the numbers are representative, not measured from a real muscle.

Twitch. Each stimulus gives a twitch: a 5 ms latent period (the action potential spreads and Ca²⁺ is released, with no force yet), a contraction phase peaking 35 ms later, and a slower relaxation as Ca²⁺ is pumped back. Twitches add when a stimulus arrives before the last one has relaxed (wave summation). The total is capped at 4 × one twitch, close to OpenStax’s “three to four times” for tetanus. The Ca²⁺ lane is a sketch that rises 1–10 ms after each stimulus, before the force; it is not a measured calcium signal.

Sarcomere. Thick filaments 1.6 µm long with a 0.2 µm bare middle; thin filaments 1.0 µm from each Z disc. So the A band is always 1.6 µm, the I band is the sarcomere length − 1.6 µm, and the H zone is the length − 2.0 µm. Active force follows the overlap: a plateau from 2.0 to 2.2 µm, falling in a straight line to zero at 3.6 µm (no overlap) and to half at 1.6 µm (thin filaments overlapping each other, thick filaments reaching the Z discs). Real curves are close to this but rounded. The bench goes no shorter than 1.6 µm.

Isometric. The muscle is held at a fixed length, so it pulls on the sensor rather than shortening. The sarcomere picture shortens by up to 0.2 µm at full force, as real sarcomeres do a little while the tendons stretch; the recorded band widths are for the set length at rest.

Without ATP. After the switch at 0.40 s the force moves (time constant 40 ms) to the model’s value for that condition: zero when Ca²⁺ is blocked and ATP is present, and an illustrative 40% of maximum (1.6 × one twitch) when ATP is gone, with or without Ca²⁺, because bound heads cannot let go. Real rigor force varies.

Not included. Motor unit recruitment, fatigue, passive (elastic) tension of a stretched muscle, temperature, and the muscle’s own action potential.

What am I looking at?

How the lab works. Pick Explore or one lab at the top. Each lab has five tabs: Pre-lab, Bench, Data & graph, Claim · Evidence · Reasoning, and Test. On the Bench, the coach lists your steps; they tick themselves as you work. Press What do I do now? when you’re stuck.

The apparatus (top left). A stimulator sends short electrical pulses through two electrodes into an isolated skeletal muscle. One tendon is clamped; the other pulls on a force transducer. The micrometer under the transducer sets how stretched the muscle (and every sarcomere) is.

The force trace (top right). Force against time for one second. Under it, the Ca²⁺ level in the fiber and a red mark for every stimulus, on the same time axis.

The sarcomere (lower left). One unit of a myofibril from Z disc to Z disc: blue thin (actin) filaments anchored at the Z discs, orange thick (myosin) filaments in the middle. The brackets measure the A band, H zone, I band and the sarcomere.

The close-up (lower right). One myosin head under an actin filament, with tropomyosin (dark rope), troponin (green) and Ca²⁺ (yellow). Orange patches are the myosin-binding sites. Use Step › to walk through the cross-bridge cycle; during a run it follows the muscle.

Keys: Space stimulate · → next cross-bridge step.