Skip to main content
Back to Biology

HOMEOSTASIS · WATER TRANSPORT IN PLANTS

Transpiration Lab

AP Biology
File ▾

AP BIOLOGY · PLANT WATER TRANSPORT AND WATER POTENTIAL

How fast does a leafy shoot drink, and why?

Leaves lose water vapour through tiny pores called stomata, and the plant pulls up water to replace it. A potometer lets you measure that pull: an air bubble creeps along a millimetre scale as the shoot takes up water.

  1. Set up the shoot and the conditions: still air, a lamp, a fan or a misted bag.
  2. Run it for 10 minutes and watch the bubble move along the scale.
  3. Record the run, then turn millimetres into millilitres and compare.

Choose where to start:

About this model

A teaching model, not a measured plant. Water uptake per square metre of leaf = 2.0 mL/m²/min × an environment factor × a stomata factor. The environment factors are room air 1, bright lamp 1.6, fan 2.2 and misted bag 0.35; the 2.0 mL/m²/min (about 1.9 mmol of water per m² per second) is an illustrative indoor rate. Real shoots vary with species, age, temperature and time of day.

Stomata. The stomata factor is 0.04 + 0.96 × (open stomata per mm² on both surfaces ÷ 200). The shoots have 20 stomata per mm² on the upper surface and 180 on the lower, so the factor is 1. Petroleum jelly closes every stoma on the surface it covers; the 0.04 that is left stands for water lost through the waxy cuticle. In real leaves, how wide the stomata open matters as much as how many there are; this model keeps the opening fixed for each environment.

Water potential. The potometer water is pure (Ψ = 0 MPa). Leaf Ψ = −0.25 MPa for every 1 mL/m²/min of transpiration, and the stem is halfway between (illustrative). Air Ψ = 135 MPa × ln(relative humidity) at 20 °C (from Ψ = RT/V̄w · ln RH): room and fan air 70 % (−48 MPa), lamp-warmed air 65 % (−58 MPa), misted bag 90 % (−14 MPa). Ψ sets which way water moves; how fast vapour leaves depends on the leaf-to-air vapour difference and on the stomata and the still boundary layer of air, which is why a fan speeds transpiration with the same air Ψ.

The potometer. The capillary’s inside radius is 1.0 mm, so 1 mm of bubble travel is π × 1.0² = 3.14 mm³ = 0.00314 mL. The bubble is read to 1 mm once a minute; when it passes 240 mm the reservoir tap pushes it back to 0 and the distance already moved is kept. Each real run differs from the model by a few percent (random, up to ±8 %). A potometer measures uptake, not transpiration itself: a little water stays in the shoot.

Leaves and peels. Leaf areas: Shoot A 0.0060 m², B 0.0120 m², C 0.0200 m² (one side). Tracings are on 80 g/m² paper (0.80 g per 100 cm²) with up to ±2 % tracing error. Peels are viewed at 400× with a field 0.45 mm across (0.159 mm²). The bench picture is a schematic and not to scale.

What am I looking at?

How the lab works. Pick Explore or one lab at the top. Each lab has five tabs: Pre-lab, Bench, Data & graph, Claim · Evidence · Reasoning, and Test. On the Bench, the coach shows your next step; steps tick themselves as you work. Press What do I do now? when you’re stuck.

The bench. A leafy geranium shoot sits in an airtight rubber bung on a glass tube full of water, held by clamps on a ring stand. The tube runs into a thin capillary tube fixed along a white millimetre scale; its far end dips into a beaker of water. As the shoot takes up water, the air bubble in the capillary moves left along the scale (the orange tag shows its reading). The reservoir and tap above the tube push the bubble back to 0 when it nears the end. Top right: the air temperature and humidity, and the stopwatch.

The environments. A desk lamp, a fan (its air streams over the leaves) or a clear plastic bag misted inside. A shiny glaze on the leaves means petroleum jelly. Faint dots drifting off the leaves stand for water vapour: more dots, faster transpiration.

The graph. Water taken up (mL) against time (min). The steeper the line, the faster the uptake. Your recorded runs stay on it as hollow markers.

Keys. Every button works with Tab and Enter. In the Microscope station you can type your count without tapping.