Skip to main content
Back to Physics

MOTION & FORCES · DYNAMICS

Atwood & Incline Dynamics Lab

AP Physics 1
File ▾

AP PHYSICS 1 · UNIT 2 · FORCE AND TRANSLATIONAL DYNAMICS

What sets the acceleration?

Two masses on a string over a pulley, and a block sliding down a slope. Measure each one’s acceleration with a motion sensor, then explain it with free-body diagrams and Newton’s second law, for one object or for a whole system.

An Atwood machine: two stacks of brass slotted masses hang from a string over a red pulley, beside a wooden incline with a block on it.
  1. Set up the masses, the pulley, the angle or the surface.
  2. Release it. The motion sensor graphs position and velocity as it moves.
  3. Fit a line to the velocity graph: its slope is the acceleration. Record it, then explain it with forces.

Choose where to start:

What am I looking at?

The pulley, hangers and blocks are drawn larger than life so you can see them. Heights on the meter stick and distances along the board are to scale.

About this model

Atwood machine. With the string and pulley treated as massless and frictionless, the two masses form one system: the net external force along the string is (m₂ − m₁)g and the mass being accelerated is m₁ + m₂, so a = (m₂ − m₁)g ÷ (m₁ + m₂). Single-object models give the tensions: T₁ − m₁g = m₁a and m₂g − T₂ = m₂a. Positive a means mass 2 moves down. g = 9.8 m/s².

Heavy pulley. A pulley with rotational inertia I needs a net torque to spin up: (T₂ − T₁)r = Iα, with α = a/r. That adds I/r² to the inertia of the system: a = (m₂ − m₁)g ÷ (m₁ + m₂ + I/r²). The heavy pulley is a solid disk, I = ½MR², so I/r² = 0.25 kg.

Incline. Along the slope, mg sin θ pulls the object down and kinetic friction μₖN acts up the slope while it slides down; perpendicular to the slope, N = mg cos θ. So a = g(sin θ − μₖ cos θ), the same for any mass. Every run starts with a 0.80 m/s push, so the object is already sliding: if μₖ is larger than tan θ, a is negative and the object slows down and stops. It then stays at rest, because static friction (up to μₛN, with μₛ ≥ μₖ) can balance mg sin θ.

Surfaces. The cart is modeled as frictionless (real carts have a little rolling friction). The wood block uses μₖ = 0.30 (wood on wood, OpenStax College Physics Table 5.1). Pads X and Y have made-up coefficients chosen for teaching; you find them from your data.

The motion sensor. It records position 40 times a second with about ±1 mm of noise, and works out velocity from the change in position between samples, so the velocity points scatter a little. The best-fit line averages that scatter out. These readings are simulated, not real measurements.

What is left out. Air resistance, the mass and stretch of the string, friction in the pulley’s bearing, the cart wheels’ spin, and how friction really varies with speed and wear. Everything in the model is a simplification you can test against your data.