Skip to main content
Back to Physics

THERMODYNAMICS · AP PHYSICS 2

Heat Engine Cycle Lab

AP Physics 2
File ▾

AP PHYSICS 2 · UNIT 9 · THERMODYNAMICS

Heat in, work out, and the heat you can’t keep

A heat engine takes in heat from something hot, turns part of it into work, and gives the rest to something cold. Here a sealed cylinder of gas moves between a hot reservoir, an insulating stand and a cold reservoir, pushing a piston that turns a flywheel. Its PV diagram traces a loop, and the area inside that loop is the work.

A clockwise loop on a pressure-volume graph with its enclosed area shaded, beside a piston engine whose flywheel it turns.
  1. Run the engine one stroke at a time and watch the gas, the piston and the PV loop.
  2. Measure the heat Q and the work W done on the gas in each stroke, with W = −PΔV and ΔU = Q + W.
  3. Compare the work out with the heat in, and with the Carnot limit 1 − TC/TH.

Choose where to start:

What am I looking at?

The engine is a schematic: the piston’s travel shows how the volume changes during a cycle, not the true size of the cylinder.

About this model

The gas. 1 mol of an ideal monatomic gas (like helium or argon, and like the AP exam’s ideal gases): PV = nRT, internal energy U = 3/2 nRT, R = 8.31 J/(mol·K). U depends only on the temperature.

Signs. As on the AP Physics 2 equation sheet: ΔU = Q + W, where Q is the heat into the gas and W the work done ON the gas, W = −PΔV for a constant pressure. Some college books use ΔU = Q − W with W done BY the gas; the physics is the same, only the sign of W flips.

The strokes. Constant volume: W = 0, so Q = ΔU. Constant pressure: W = −PΔV. Constant temperature (isothermal): ΔU = 0, so Q = −W, with W = −nRT ln(Vf/Vi). Insulated (adiabatic): Q = 0, so W = ΔU, and PV5/3 stays constant, which is why an adiabat is steeper than an isotherm.

Two engines. The rectangle cycle heats and cools at constant volume and expands and compresses at constant pressure (its corner values are chosen for teaching). The Carnot cycle takes in heat only at TH and gives it out only at TC, through two isothermal and two adiabatic strokes. It is reversible: no friction, and heat flows across tiny temperature differences, so it runs infinitely slowly. Real engines do worse.

Efficiency. e = |Wnet| ÷ QH: the share of the heat taken in from the hot side that becomes work. The best any engine can do between two reservoirs is the Carnot limit e = 1 − TC/TH (kelvin). These two equations are not on the AP Physics 2 equation sheet; this lab states them so you can use them.

What is left out. Friction, heat leaking through the walls, the time heat takes to flow, the gas’s mass and the flywheel’s inertia. A real engine also takes in fresh fuel and air each cycle; this one reuses the same sealed gas (like a Stirling engine).